Our Products: Top Sealer (TS)    Deep Penetrating Sealer (DPS)    Concrete Sealer (CS)    Repair Mortar Overlay (RMO)   

TECHNICAL
Goodcrete Concrete Sealer Instruction
Jul 19
How does Goodcrete concrete sealer work?
Jul 16
Goodcrete Concrete Sealer Instruction
Jul 16
Analysis of Common Concrete Cracking Problems by Goodcrete
Jul 16
PRODUCTS
Top Sealer (TS)
Deep Penetrating Sealer (DPS)
Concrete Sealer (CS)
Repair Mortar Overlay (RMO)

LINKS
Online trade
goodcrete.1688.com

 
TOP SEALER (TS)


PRODUCT DESCRIPTION

Goodcrete TS, is a patented dual crystalline penetrating concrete and masonry sealer that is 100% water-based compound (H2O) containing only natural ingredients. Designed to protect surfaces from the delaminating effects of water, moisture saturation, freeze/thaw, Alkali Silica Reaction (ASR), and chloride ion penetration.
The protective properties are a distinctive surface repellent and moisture blocker, offering hygroscopic and hydrophilic capacities. TS is ideal for exterior or interior concrete and masonry surfaces and can be applied in both positive or negative side applications. TS will dramatically reduce maintenance costs and positively affect the life cycle of concrete and masonry products.



ADVANTAGES & BENEFITS
· Can be used on green & cured concrete.
· 100% green, environmentally safe, & non-toxic.
· Reduce damage caused by repeated freezing and thawing cycles.
· Prevents concrete scaling.
· Seals and protects cracks up to 1/16th inch (1.5 mm).
· Reduces alkali-silica damage and can reduce silicate dusting.
· Can help reduce calcium oxychloride reaction due to use of magnesium chlorides.
· Reduces and/or eliminates early joint deterioration.
· Prevents penetration of chloride ions from de-icing salts.
· Excellent repelling properties that help prevent water, jet fuel, and oil from saturating into the surface.
· Helps concrete stay whiter and brighter.
· Protects reinforcing steel bars against corrosion without any negative effects on existing steel cathodic protection.
· Maximizes joint sealant adhesion by reducing moisture.
· Can be applied vertically, horizontally, and overhead.
· Provides long-lasting internal waterproofing and moisture blocking from positive and negative sides.
· Eliminates fungal growth


 

FIELDS OF APPLICATION

Airports
Highways

Tunnels
Bridge structures

Parking surfaces & structures
Sidewalks & drives

Retaining walls
Precast/tilt concrete


TECHNICAL SPECIFICATIONS
Specific Gravity 1.1 1.2
Viscosity 2.4 centipoises
Freezing Point 25ºF (-3.89°C)
Boiling Point :219ºF (104°C)
Color :Clear
Environmental Hazards None
Drying Time @ 77ºF (25°C) 2 3 hours
Odor None
Toxicity None
Fumes None
Flammability None

Fully cured or existing concrete: Repair and seal joints, cracks,
and voids greater than 1/16th inch prior to application. Concrete
surfaces must be clean and sound prior to application of the
product. Proper cleaning will open the surface pores and
capillaries to enhance the penetration process. Compressed air
can be used to remove dust and loose particles from the
surface. Flushing the area to be treated with water can improve
the cleaning process. However, for heavily contaminated areas
special concrete cleaning agents such as Chem-Crete
CONCLEAN CCC060 can be used to remove dirt, grease, and oil
from those areas.
Green/plastic application:
1) A test should always be performed for product
absorption.
2) Only consider an application when concrete finishing is
completed.
3) Concrete should not be in duress and should be curing
normally.
4) Apply when all bleed water has dissipated from the surface.
5) Apply Pavix uniformly and at the
manufacturer’s recommended rate.
6) DO NOT allow the Pavix to puddle or pool. Should Pavix
puddle or pool, remove this condition immediately by the
best way possible. Additional movement of product with a
broom, vacuum, or air blower is recommended.
7) Application of membrane forming curing compound should
then immediately commence and not longer than 20
minutes from the initial Pavix application.
8) Apply the membrane curing compound at
manufacturer’s recommended coverage rate.

 

Coverage: Apply at an average coverage rate of 150-200 ft2/gal
(3.7-4.9 m2/liter) in one coat. Do not attempt additional
coatings.

Limitations: Do not apply PAVIX in the following cases:
· If concrete surface temperature falls below 40°F (5°C).
· If the area has been previously treated with sealing agents
unless the sealers are removed by chemical or mechanical
means.

 

STORAGE

TS must be stored under room temperature. Cold
temperatures may cause the product to crystallize. Shelf life is
two years in its original unopened packaging. Do not allow
product to freeze.

 

SAFETY PRECAUTIONS

As with all construction chemical products, adequate precautions and care must be taken during usage and storage. Avoid direct contact with foodstuff, eyes, skin, and mouth. Any direct contact with skin should be washed thoroughly with clean
running water and soap. Always wear protective goggles and gloves. In case of eye contact, flush for 15 minutes with warm water. If eye irritation persists, seek medical attention. In case of ingestion or swallowing, drink 2 glasses of clean water and seek medical attention. Keep out of reach of children.

 

WARRANTY

Limited Warranty: International Chem-Crete Inc. warrants that, at the time and place we make shipment, our materials will be of good quality and will conform to our published specifications on the date of acceptance of the order. Disclaimer: The information contained herein is included for illustrative purposes only and, to the best of our knowledge, is accurate and reliable. International Chem-Crete Corp. is not under any circumstances liable for the use of this information, as International Chem-Crete Corp. has no control over the use to which others may put its products. It is recommended that the products be tested to determine the suitability for specific applications and if our information is valid in particular circumstances. Responsibility remains with the architect, engineer, contractor, and owner of the application for proper installation of each product. Specifier and user shall determine the suitability of the product for specific application and assume
all responsibility in connection therewith. AM160818PR1-3.


 

Email: Linda@goodcrete.com
Tel:13503217507
CopyRight © 2014-2017
GOODCRETE
, All Rights Reserved. 
About us
Products
News
Videos
FAQ
Technical
Joblist
Contact us